MakerFocus 10pcs NRF24L01+ 2.4GHz Wireless RF Transceiver Module Compatible with Arduino Raspberry Pi

Specification: 100% Quality Guarantee Model: nRF24L01 nRF24L01 is a single chip radio transceiver for the world wide 2.4 - 2.5 GHz ISM band The transceiver consists of a fully integrated frequency synthesizer, a power amplifier, a crystal oscillator, a demodulator, modulator and Enhanced ShockBurst protocol engine Output power, frequency channels, and protocol setup are easily Programmable through a SPI interface. Current consumption is very low, only 9.0mA at an output power of -6dBm and 12.3mA in RX mode Built-in Power Down and Standby modes makes power saving easily realizable Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control applications 125 Communications channels, multipoint communication and frequency hopping to meet the communication need Built-in hardware CRC error detection, multipoint communication address control Low-power 1.9 ~ 3.6V, only 1uA on Power down mode Built-in 2.4Ghz antenna Available software to set the address, only received local address when output data(provide interrupt instruction), can be directly connected to a variety of microcontrollers, software programming is very convenient Support 6 Data channels of data reception Standard DIP Pitch Interface for embedded applications You Will Get: 10 pieces of NRF24L01 + 2.4GHz RF Wireless Transceiver Module Note: Please check pictures for more details Transceivers integrated module, transmit or receive can not be simultaneously by one module

• nRF24L01 is a single chip radio transceiver for the worldwide 2.4 - 2.5 GHz ISM band. Compatible with Arduino and Raspberry Pi
• Applications: Wireless peripherals, remote control systems such as RC vehicles and consumer remote electronics, wireless voice transmission such as VoIP, wireless sensor networks, wireless networks, home and commercial automation
• Ultra Small: 15x29mm (including: built-in 2.4GHz antenna), for easy implementation into designs without additional hardware
• Auto-acknowledge and auto-retransmit function
• You can find several resources available online easily, such as tutorials, data sheets, and notes